The OS Eliminator enables the disconnection of the factory oxygen sensor (lambda probe) from the motorcycle’s main wiring harness without getting an FI error code.

•Plug ‘n Go
Comes with model-specific connectors, no splicing/soldering is required. Just plug it in and enjoy the ride!
•3 switch positions
Now you can either fully open or close the exhaust valve on your bike. Or leave it in stock mode – you decide.
•Quick and easy installation
It connects in line with the original servo motor, installation is super-quick and straightforward.

Motorcycle manufacturers equip O2 sensors to the exhaust systems to measure the exhaust-gas concentration of oxygen of the internal combustion engines. The ECU
calculates the value measured by the O2 sensor and, if required, dynamically adjusts the air-fuel ratio for two main reasons: to keep emissions as low as possible and to
keep fuel consumption as low as possible. However, keeping emissions down usually means the bike is running lean, mostly in the lower RPM range, resulting in choppy
power delivery, lagging throttle response and a jerky feel.

Whether you just simply want to disconnect a faulty O2 sensor, or opt for a dyno tune, the O2 sensor is in your way. However, disconnecting the O2 sensor from the bike’s
main wiring harness will instantly result in the FI light coming on.

The OS Eliminator will eliminate the FI light as soon as you plug it into the O2 sensors connector. As the OSE is delivered with bike-specific plugs, no splicing or and other
modification to the bike’s original wiring is required. A 100% plug n’ go solution!